Furnace Repair · White Rock

Gas Furnace Repair in White Rock, BC

A furnace that quits on a wet White Rock night is urgent, but it is rarely the end of the furnace. Most failures come down to a handful of parts, and a proper diagnosis tells you whether this one is worth fixing.

Diagnosis starts with what the furnace is doing: not starting at all, trying to light and failing, lighting and shutting off, running constantly, or blowing cold air. The flashing light on the control board narrows the search; the technician confirms it with a meter before replacing anything.

Common furnace faults

  • Ignitor and flame sensor. Hot surface ignitors crack with age, and flame sensors coat over and stop proving the flame, so the burners light for a few seconds and shut off.
  • Pressure switch and venting. High-efficiency furnaces vent through plastic pipe and make a lot of water. A blocked condensate trap, a sagging drain line, or a vent that collects water trips the pressure switch.
  • Inducer and blower motors. Bearings wear and capacitors fail. A rising whine or rattle is often the warning before it stops.
  • Control board and limit switches. A tripping high limit usually means poor airflow: a clogged filter, closed registers or undersized ducts, which should be fixed rather than the switch replaced.
  • Thermostat and wiring. Dead batteries, a failed smart thermostat or a loose wire account for more no-heat calls than people expect.

When repair stops making sense

A cracked heat exchanger is a carbon monoxide risk and means replacement. On a furnace near or past twenty years, a control board or inducer may still be repairable, but you get the repair price and the replacement price side by side so the decision is yours.

Who does the work

Repairs on gas appliances are done by a certified gas fitter working for a contractor licensed with Technical Safety BC. If you smell gas, leave the house and call FortisBC at 1-800-663-9911 or 911 first.

Furnace not heating? Call 778-900-6831 or request a quote, or see our 2026 furnace repair cost guide for White Rock for real price ranges first.

Frequently asked questions

Can I reset my furnace myself?

Turning the power off and on at the furnace switch is fine to try once. Repeated resets that get it running for a few minutes usually mean a sensor, drain or venting fault that needs to be fixed.

Do you repair all furnace brands?

Yes, any make. The model and serial number from the label inside the furnace door help when you call.

Is there a charge for the diagnostic visit?

Service calls carry a diagnostic charge, stated when you book. The repair is quoted before any work starts.

Request a Quote

Call 778-900-6831 or send the form and we will get back to you within one business day.

By submitting this form, you agree to be contacted by phone, text, or email about your request. You can opt out at any time. Your details go only to the one local furnace and heating contractor who handles your job — nobody else.

Serving White Rock and surrounding areas. Contact us for a no-obligation quote specific to your property.

Call Now: 778-900-6831